How do I install W1 Firmware update? (MacOS)

1. Connect your OKIOCAM to your computer using the attached USB cable.
2. Go to https://www.okiolabs.com/product/okiocam-w1/(click to open in a new tab).
3. Scroll to the bottom of the page, click on OKIOCAM W1 Firmware Update Tool to start the download.
4. After the download has completed, click on the upward-facing arrow in the bottom left-hand corner.
   
   
   
5. Select show in folder
   
6. After the file has opened in Finder, right-click on it and select Open With > Archive Utility (default).
   
   
   
7. After opening the folder, double-click on OKIOCAM Firmware Update Tool to launch it.
   
   
   
8. You’ll see a message asking you to confirm that you wish to launch the program. Click Open.
   
   
   
9. The OKIOCAM Firmware Update Tool will open. Click Update.
   
10. Confirm that you wish to proceed with the update by clicking OK.
    
11. Your OKIOCAM’s firmware will then be updated. The process normally takes no more than several seconds. Once the update is complete, you will see the message below. Disconnect and reconnect your OKIOCAM.
    
12. Done, your W1 should be up to date now.